Airbag Anti-Drop Phone Case

Product Detailed Description

The case is a fitted shell wrapping a phone, each corner shaped into a raised pocket rather than a flat edge. The pockets sit proud of the back panel, forming thick pads and keeping the camera lens above the surface when the phone lies down. The body is continuous flexible polymer, thin side walls flexing while you slide the phone in and a deeper frame holding each corner seated. Openings cut along the bottom edge and the side leave the charging port, speaker and buttons reachable through the case. On a counter or in a tray the back panel faces outward, clear for a printed logo across its face.

• Each corner carries a small recessed pocket within the molded bumper, leaving a thicker band where the case edge meets a hard surface
• A continuous piece of flexible polymer wraps the phone from edge to edge, with no seams or separate panels to assemble
• Openings line up with the charging port, speaker and buttons, so you plug a cable or press a key without removing the case
• You line the phone against the lips and press each corner down until the frame sits flush along the device edge
• Stocked in matched runs, the case shows a clear flat face to the buyer and the raised corners read as its identifying shape