Customizable Logo 2-in-1 Magnetic TPU+PC Case

Product Detailed Description

A polycarbonate panel sits against the phone's back, wrapped by a thermoplastic polyurethane sleeve that curls past the screen rim. You set the phone into the TPU lip, then press the polycarbonate shell onto the back until the sides settle flush. The outer face carries color-blocked zones under a soft-touch oil coating, giving a logo a clean flat area to sit on rather than a busy surface. Magnetic strips sit inside the rear panel, the face that aligns to a charging pad when you lay the phone down. On a shelf or in a hand, the two-tone exterior distinguishes itself from a plain molded shell.

• Polycarbonate back gives the phone a flat landing surface while the TPU edges flex under your palm as you grip and adjust the case
• The TPU lip rises past the screen glass so when you lay the phone face-down the panel hovers above the desk
• A soft-touch oil coating covers the color-blocked zones so fingertips meet a velvety finish rather than glossy bare plastic on the back
• Color-blocking divides the outer shell into distinct tone panels so the eye separates logo from surface at a glance on a busy display rack
• Magnetic strips sit between the polycarbonate layer and the outer coating keeping the rear face smooth without exposed metal or a raised ridge